All the ports - how to save time if you have …

This article shows you how to install the port skeletons.  This will allow you to just cd into a directory and issue the make command.  You won't have to fetch anything manually.
22 August 1998
Well, it's not actually installing all of the ports.  It's more like putting the ports on hard disk instead of the CD.  And it's just the port skeletons.  A port skeleton allows you to just do a "make install" in order to install the port.   That's the beauty of ports.  It's all automatic.
I did this by performing the following steps after inserting the CD#1 of the FreeBSD set into the CD-ROM drive.
/stand/sysinstall
Configure
Distributions
ports
I waited for about 30 minutes while the files were transferred to my hard drive. Then I installed DHCP again.
For an example of how I used the above to actually install a port, see what I did when I
reinstalled DHCP
.


本文来自ChinaUnix博客，如果查看原文请点：http://blog.chinaunix.net/u/4206/showart_523826.html

标签：

版权申明：本站文章部分自网络，如有侵权，请联系：west999com@outlook.com
特别注意：本站所有转载文章言论不代表本站观点，本站所提供的摄影照片，插画，设计作品，如需使用，请与原作者联系，版权归原作者所有