a new hard drive

2009-05-13 13:19:32来源:未知 阅读 ()

新老客户大回馈,云服务器低至5折


This is a lost and found article. I wrote it some time ago, but for whatever reason, most likely stupidity, it was never published. During a recent rework of the site, I found the article and added it to the database.
14 August 1998
I bought a new hard drive tonight.  It should give me enough space to install and
upgrade to 2.2.7
.  Unfortunately, I need a new I/O board as my current one doesn't have enough IDE channels.  Tune in tomorrow for the upgrade results.
22 August
Today a new IDE card arrived which contains two IDE connectors.  This should allow me to get both hard drives and my CD-ROM running.  The main problem is IRQ conflicts.   I'm trying to reconfigure one of my network cards, but without success.  I've managed to get the system to boot with the new card but not with both network cards installed.  This is not good.  It seems that one network card is preventing the system from working.
The cards were not the same.  If one was installed, it would prevent the system from finding the hard disk.  I suspected an IRQ conflict.  However, setting the suspect card to the same values of the other card did not change the situation.  I was unable to get the two existing cards to work.  So I swapped one of the cards for one from another machine.  That allowed both machies to work.
The next thing to do is to get both drives running at the same time.


本文来自ChinaUnix博客,如果查看原文请点:http://blog.chinaunix.net/u/4206/showart_523822.html

标签:

版权申明:本站文章部分自网络,如有侵权,请联系:west999com@outlook.com
特别注意:本站所有转载文章言论不代表本站观点,本站所提供的摄影照片,插画,设计作品,如需使用,请与原作者联系,版权归原作者所有

上一篇:improving security *

下一篇:All the ports - how to save time if you have the d