Mailman - additional virtual domains

In
a recent
[url=javascript:;]Mailman[/url]
article, we learned how to install and configure
Mailman
with
Postfix
on
[/url]
[url=javascript:;]FreeBSD
. We added a single
[url=javascript:;]virtual[/url]
domain, lists.freebsddiary.org. Today, I'll add in lists.freshports.org.
NOTE: to avoid the spambots, I have changed some instances of lists.freshports.org to lists.example.org. Please keep that in mind.
NOTE: this article assumes you have set Mailman up as shown in the previous article.
To create the
[url=javascript:;]new[/url]
list:
cd /usr/local/mailman
bin/newlist --urlhost=lists.freshports.org \
--emailhost=lists.freshports.org freshports-beta
This will send out a list creation email such as this:
The mailing list `freshports-beta' has just been created for you.  The
following is some basic information about your mailing list.
Your mailing list password is:
abcdef
You need this password to configure your mailing list.  You also need
it to handle administrative requests, such as approving mail if you
choose to run a moderated list.
You can configure your mailing list at the following web page:
http://havoc.example.org/mailman/admin/freshports-beta
The web page for users of your mailing list is:
http://havoc.example.org/mailman/listinfo/freshports-beta
You can even customize these web pages from the list configuration
page.  However, you do need to know HTML to be able to do this.
There is also an email-based interface for users (not administrators)
of your list; you can get info about using it by sending a message
with just the word `help' as subject or in the body, to:
freshports-beta-request@havoc.example.org
To unsubscribe a user: from the mailing list 'listinfo' web page,
click on or enter the user's email address as if you were that user.
Where that user would put in their password to unsubscribe, put in
your admin password.  You can also use your password to change
member's options, including digestification, delivery disabling, etc.
Please address all questions to mailman-owner@havoc.example.org.
In this email, the URLs refer to havoc.example.org, which is the hostname of the system on which I installed Mailman. The URL should be lists.freshports.org. I will fix that with this command:
bin/withlist -l -r fix_url freshports-beta --urlhost=lists.freshports.org
With this change, I was able to browse to the mailman interface and see the lists:
http://lists.freshports.org/mailman/listinfo
I then tried to send email to the list. It failed:

标签：

版权申明：本站文章部分自网络，如有侵权，请联系：west999com@outlook.com
特别注意：本站所有转载文章言论不代表本站观点，本站所提供的摄影照片，插画，设计作品，如需使用，请与原作者联系，版权归原作者所有