Installing Samba 3.0.x on OpenBSD

2009-05-13 08:56:33来源:未知 阅读 ()

新老客户大回馈,云服务器低至5折


The following steps can be used to install
Samba

3.0.14a
on
  
OpenBSD
.
  Notes:
  

  • These steps seem to work on OpenBSD
    3.7
    . Click one of the following
        links for instructions covering prior releases:
       
    3.6
       

  • The ports
        collection needs to be installed. See the
    OpenBSD FAQ
        for directions on how to install the ports collection.

  • Click one of the following links for copies of the samba config file
       
    smb.conf
    :
       
       
    default
    ,
       
    modified
    .
       

  Related Urls:
  
  • The
        Unofficial Samba HOWTO
  • Samba's
        Encrypted Password Support

  Steps:
  

  •       
    Untar the port in /usr/ports/net/samba:
          # cd /usr/ports/net/samba
    # ftp
    http://www.csua.berkeley.edu/~ranga/patches/port-obsd37_net_samba_3.0.14a.tgz
    # tar -xvzf port-obsd37_net_samba_3.0.14a.tgz
       

  •       
    Build samba:
          # cd 3.0.14a
    # make install
       

  •       
    Add the following to /etc/rc.local in order to have Samba
          automatically started during boot:
          if [ -f /etc/samba/smb.conf -a X"${samba}" != X"NO" ]; then
           if [ X"${smbd_flags}" != X"NO" -a -x /usr/local/libexec/smbd ]; then
               echo -n ' smbd';    /usr/local/libexec/smbd ${smbd_flags}
           fi
           if [ X"${nmbd_flags}" != X"NO" -a -x /usr/local/libexec/nmbd ]; then
               echo -n ' nmbd';    /usr/local/libexec/nmbd ${nmbd_flags}
           fi
    fi
    This can be added around line 19 in /etc/rc.local.
       

  •       
    Enable Samba:
          # echo 'smbd_flags="-D"' >> /etc/rc.conf.local
    # echo 'nmbd_flags="-D"' >> /etc/rc.conf.local
    To run Samba without NetBIOS name resolution (nmbd), set
    nmbd_flags=NO instead.
       

  •       
    Customize /etc/samba/smb.conf:
          

    •          
      Set the workgroup by change the following:
                workgroup = MYGROUP
      to
                workgroup =

      标签:

      版权申明:本站文章部分自网络,如有侵权,请联系:west999com@outlook.com
      特别注意:本站所有转载文章言论不代表本站观点,本站所提供的摄影照片,插画,设计作品,如需使用,请与原作者联系,版权归原作者所有

  • 上一篇:一些 Mysql 的优化经验

    下一篇:ascii表