OpenBSD4.1安装

                                                                                                                                此文讲述在winxp下
用VMware通过nat网络方式虚拟安装OpenBSD4.1
#从ftp.freebsdchina.org/pub/openbsd/4.1/i386下载安装的引导文件cd41.iso,系统从光盘启动,自检略...
erase ^?, weras ^W, Kill ^U, intr ^C, status ^T
(I)nstall, (U)pgrade or (S)hell? I
#
其中(I)代表安装一个全新的系统，(U)代表升级原有的OpenBSD旧版本的系统，(S)代表退出并进入命令行状态。
我们要安装一个全新的OpenBSD系统，所以我们在这里输入I，并回车。（当然你也可以按下Ctrl+C退回到命令行状态，再次输入install回到安装程序，如果在安装程序时误操作，可以使用这种方法进入命令行状态然后再重新回到安装程序开始安装。）
Welcome to the OpenBSD/i386 4.1 install program.
This program will help you install OpenBSD in a simple and rational way. At any prompt except password prompts you can run a shell command by typing '!foo', or escape to a shell by typing '!'. Default answers are shown in []'s and are selected by pressing RETURN. At any time you can exit this program by pressing Control-C and then RETURN, but quitting during an install can leave your system in an inconsistent state.
选择终端类型
Terminal type? [vt220]
kbd(8) mapping? ('L' for list) [none]
IS YOUR DATA BACKED UP? As with anything that modifies disk contents, this program can cause SIGNIFICATION data lose.
It is often helpful to have the installation notes handy. For complex disk configurations, releavant disk hardware manuals and a calculator are useful.
安装程序提示是否开始安装，我们直接输入y，并回车
Proceed with install? [no] y
Cool! Let's get to it.
You will now initialize the disk(s) that OpenBSD will use. To enable all available security features you should configure the disk(s) to allow the creation of separate filesystem for /, /tmp, /var, /usr, and /home.
Available disks are: wd0.
Which one is the boot disk? (or 'done') [wd0]
在OpenBSD系统中对于IDE接口的硬盘的命名方式是wd0，wd1，wd2……依次类推，而SCSI接口的硬盘则是sd0，sd1，sd2……依次类推。
Do you want to use *all* of wd0 for OpenBSD? [no] y
系统询问是否将检测到的整个硬盘都给OpenBSD使用，默认是no，但是我们在这里是要将OpenBSD作为服务器来用，所以我们在这里输入yes，并回车。
Putting all of wd0 into an active OpenBSD MBR partition (type 'A6')...wd0: no disk labeldone.
You will now create an OpenBSD disklabel inside the OpenBSD MBR partition. The disklabel defines how OpenBSD splits up the MBR partition into OpenBSD partitions in which filesystems and swap space are created.

标签：

版权申明：本站文章部分自网络，如有侵权，请联系：west999com@outlook.com
特别注意：本站所有转载文章言论不代表本站观点，本站所提供的摄影照片，插画，设计作品，如需使用，请与原作者联系，版权归原作者所有