FreeBSD/sparc64 5.0-CURRENT Installation

http://people.freebsd.org/~murray/sparc64/install.html
Instructions
        The FreeBSD Project
        Copyright © 2000, 2001, 2002 by
        The FreeBSD Documentation Project
        
      
      
        
         
         
This article gives some brief instructions on
          installing FreeBSD/sparc64 5.0-CURRENT. Please keep in
          mind that this port is a work in progress, and as such,
          the installation procedure is much more involved than
          FreeBSD/i386 or FreeBSD/alpha.
        
      
      
        
        
1 Installing
        FreeBSD
        
This text describes how to install and boot the sparc64
        port. Only net-booting of the kernel is covered right
        now.
        
         
            
Warning: The kernel and userland binaries
            mentioned below are highly experimental (for example,
            the kernel contains some ATA changes and eeprom
            handling code). Unless you know what you are doing and
            are willing to cope with any damage that might arise,
            you should probably not be trying this! So, use at your
            own risk!
         
        
        
         
          1.1 Configuring the
          netboot server.
         
A sparc64 kernel is booted by having the firmware
          retrieve and execute a loader program, which in turn
          fetches and executes the actual kernel. For this boot
          process you need to set up rarpd and tftp (for the
          firmware) and bootp (for the loader) on another networked

标签：

版权申明：本站文章部分自网络，如有侵权，请联系：west999com@outlook.com
特别注意：本站所有转载文章言论不代表本站观点，本站所提供的摄影照片，插画，设计作品，如需使用，请与原作者联系，版权归原作者所有