Stop-A on Serial Console?

使用Sun的机器,由于没有显卡,只能使用串口了
由于找不到Stop键,没有办法使用Stop-A的操作
如下是精华,呵呵:
See if the online docs reference a "BREAK" signal.
正解
Subject: Stop-A on
Serial
Console?
Original Message
Name:
Greg
(by inittab)
Date: July 29, 2004 at 12:18:19 Pacific
Subject: Stop-A on Serial Console?
OS: N/A
CPU/Ram: 300MHz, 256mb
Comment: Is it possible to send Stop-A to a
Sun
Ultra 30 over a serial console? Unfortunately, the system that I'm connecting from runs
Linux
and therefor does not support `tip`. Hence, I am using Columbia's
Kermit (`kermit`) to establish the connection. Everything works as
expected from the boot banner to the console login, but I would like to
be able to halt the system without booting the
operating system
first, so I need to figure out how to send such a command (Stop/L1-A). Thank you.
Report Offensive Message For Removal
Response Number 1
Name:
David Perry

Date: August 02, 2004 at 09:23:48 Pacific
Subject: Stop-A on Serial Console?
Reply: It depends a lot on your terminal package. Some key sequences to try
CONTROL-]
CONTROL-L
See if the online docs reference a "BREAK" signal.
Report Offensive Follow Up For Removal
Response Number 2
Name: nrc
Date: August 04, 2004 at 18:59:57 Pacific
Subject: Stop-A on Serial Console?
Reply: could also use alt-b, if using teraterm
Report Offensive Follow Up For Removal


本文来自ChinaUnix博客，如果查看原文请点：http://blog.chinaunix.net/u/2389/showart_30793.html

标签：

版权申明：本站文章部分自网络，如有侵权，请联系：west999com@outlook.com
特别注意：本站所有转载文章言论不代表本站观点，本站所提供的摄影照片，插画，设计作品，如需使用，请与原作者联系，版权归原作者所有